Table of Contents
Advertisement
Figure 39
1. Clutch
2. Check plug
4.
Remove the check plug allowing all lubricant to
flow into the drain pan.
5.
Rotate the clutch so the check plug is positioned
at 4:00 o'clock.
6.
Add Mobil Fluid 424 until the lubricant level is
up to the hole in the clutch. The clutch should be
approximately
1
⁄
full.
3
7.
Install the check plug.
Note: Do not use engine oil (i.e., 10W30) in the
clutch. Anti-wear and extreme pressure additives will
cause undesirable clutch performance.
Rear Wheel Toe-In
The rear wheels should not toe-in or tow-out when
they are adjusted correctly. To check the rear wheel
toe-in, measure the center-to-center distance at wheel
hub height, in front and in back of the rear tires. If the
wheels toe-in or toe-out, an adjustment is required.
1.
Turn the steering wheel so the rear wheels are
straight ahead.
2.
Remove the nuts securing one tie rod ball joint to
the mounting bracket on the axle and disconnect
the ball joint from the axle (Fig. 38).
3.
Loosen the screw on the tie rod clamp. Rotate
the ball joint in or out to adjust the length of the
tie rod.
4.
Install the ball joint to the mounting bracket and
2
1
check wheel toe-in.
5.
After attaining your desired adjustment, tighten
the screw on the rod clamp and secure the ball
joint to the mounting bracket.
Servicing the Battery
Important
Before welding on the machine,
disconnect the ground cable from the battery to
prevent damage to the electrical system .
Note: Check battery condition weekly or after every
50 hours of operation. Keep the terminals and the
entire battery case clean because a dirty battery will
slowly discharge. To clean the battery, wash the entire
case with a solution of baking soda and water. Rinse
with clear water. Coat the battery posts and cable
connector with Grafo 112X (Skin-over) grease, Toro
Part No. 505-47 or petroleum jelly to prevent
corrosion.
Wiring Harness Service
Prevent corrosion of wiring terminals by applying
Grafo 112X (Skin-over) grease, Toro Part No. 505-47,
to the inside of all harness connectors whenever the
harness is replaced.
Whenever working with the electrical system, always
disconnect battery cables, negative (–) cable first, to
prevent possible wiring damage from short-outs.
36
Advertisement
Table of Contents
