Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance
Service Interval
After the first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 1000 hours or 2
years, whichever
occurs first
Maintenance Procedure
• Check the power take-off belt tension.
• Check the fan and alternator belt tension.
• Change the transmission filter.
• Torque the wheel lug nuts.
• Change the engine oil filter.
• Torque the engine head and check engine RPM.
• Check the battery fluid level.
• Check the battery cable connections.
• Lubricate all grease fittings.
• Lubricate the brake cables.
• Check the cutting unit gear box oil level.
• Clean under the cutting unit belt covers.
• Check the cutting unit drive belt adjustment.
• Change the engine oil.
• Inspect the air filter and baffle
• Change the engine oil filter.
• Check the electric clutch gap adjustment
• Check the power take off belt tension.
• Check the fan and alternator belt tension.
• Inspect the cooling system hoses.
• Check rear wheel toe-in and steering linkage.
• Change the transmission filter.
• Torque the wheel lug nuts.
• Service the air filter
• Drain and clean the fuel tank.
• Change the cutting unit's gear box oil
• Change the fuel/water separator filter.
• Pack the rear wheel bearings.
• Coat the transmission bypass pins with grease
• Torque the head, adjust the valves and heck engine RPM.
• Replace moving hoses.
• Replace safety switches.
• Flush and replace the coolant system fluid.
• Replace the hydraulic oil.
24
Advertisement
Table of Contents
