Toro 31598 Operator's Manual page 25

To Set the Cruise Control
Increase the ground speed.
To Float the Deck
Lower the decks.
To Lower the Deck
1. The operator must be seated.
2. Select the low range.
3. Set the parking brake.
Electronics Issues
1. Fix the High/Low range switch.
2. Controller firmware incompatible.
3. Blown the fuse.
4. HHDT ready.
Engine
1. Lower the engine speed.
2. Wait to shutoff the engine.
Fuel Level
Add the fuel.
To Engage PTO
1. Solve the engine fault.
2. Let the engine warm up.
3. Let the hydraulic oil warm.
4. Lower the decks.
5. Must be in the low range.
6. Operator must be seated.
To Set High Range
1. Disengage the cruise.
2. Disengage the PTO.
3. Lift the left deck.
4. Lift the center deck.
5. Lift the right deck.
6. Reduce the ground speed.
To Set Low Range
1. Disengage the cruise.
2. Reduce the ground speed.
To Start
1. Disengage the deck switch.
2. Disengage the PTO.
3. Move the traction pedal to neutral.
4. Insert the jumper in teach plug.
5. Engine running.
6. Operator must be seated or set the parking brake.
7. Turn the key switch off then on.
8. Wait.
For Teach (Traction Pedal Calibration)
Turn the key switch off then on.
For Traction
1. Fix the critical sensor error.
2. Fix the critical voltage error.
3. Release the parking brake.
4. Move the traction pedal to neutral.
5. Operator must be seated.
For Traction Assist
1. Must be in the low range.
2. Operator must be seated.
Traction Derate Due To
1. Requires service.
2. Engine or hydraulics too hot.
3. Traction pedal sensor needs calibration.
4. Reserved 1
5. Reserved 2
6. Reserved 3
25