Zanussi ZCG61236 User Manual page 23

Check the table in chapter "Product
descriptions" to see the initial gas of
your appliance.
If the appliance is set for natural gas
you can change it to liquid gas, with
the correct injectors.
If the appliance is set for liquid gas
you can change it to natural gas,
with the correct injectors.
The gas rate is adjusted to suit.
WARNING!
Before you replace the injectors,
make sure that the gas knobs are in
the Off position. Disconnect the
appliance from the electrical supply.
Let the appliance cool down. There
is a risk of injury.
The appliance is set to default gas.
To change the setting choose a pipe
holder from the list. Always use the
gasket sealing.
A
A) Gas connection end
B) Natural Gas pipe holder
C) LPG pipe holder
Hob injectors replacement
Replace the injectors when you change the gas
type.
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. Remove the injectors with a socket spanner
7.
4. Replace injectors with the ones necessary
for the type of gas you use.
www.zanussi.com
B C
5. Replace the rating plate (it is near the gas
supply pipe) with the one for the new type
of gas supply.
You can find this plate in the
bag supplied with the appliance.
If the supply gas pressure is not constant or it is
different from the necessary pressure, install an
applicable pressure adjuster on the gas supply
pipe.
Adjusting the minimum gas level on the
hob burner
1. Disconnect the appliance from the
electricity.
2. Remove the knob for the hob. If there is no
access to the bypass screw dismount the
control panel before adjustment start.
3. With a thin and flat screwdriver adjust the
bypass screw A.
The model determines the position of the
bypass screw A.
A
Changing from natural gas to liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
Changing from liquid gas to natural gas
1. Unscrew approximately one turn the bypass
screw position A.
2. Put the knob for the hob back.
3. Connect the appliance to the electricity.
A
23