Table of Contents
Advertisement
1. Parking-brake switch
2. Power port
Note: The red parking brake indicator will appear in the
command center display
1. Parking brake indicator (command center display)
•
Release the parking brake by pushing up the parking-brake
switch.
Note: When the parking brake is released and the
machine is moved forward or backward, the Home screen
will stop displaying the parking brake indicator.
•
If you stop the engine without setting the parking brake,
the machine will set the parking brake and the yellow
parking brake indicator will appear in the command
center display
(Figure
Figure 11
3. Key switch
(Figure
12).
Figure 12
12).
Key Switch
Use the key switch to power the electrical accessories, start the
machine, and stop the machine
positions are as follows:
•
Accessory—Rotate the key switch to this position to
energize the lamp switch circuits.
•
Stop—Rotate the key switch to this position to stop the
engine and de-energize the electrical system.
Note: Always remove the key before leaving the
machine.
•
Run—This position allows the engine to run and will
energize all electrical systems.
•
Start—Rotate the key switch to this position to start the
engine.
Note: When you release the key, it will automatically go
to the Run position.
Foot Pedal
The foot pedal controls the direction and speed of travel of
the machine
(Figure
13).
1. Heel pedal (reverse)
Traction-Control Cluster
The traction-control cluster is located at the operator seat,
adjacent to the left armrest.
Utility-Traction Joystick
When trenching, plowing, or boring, use the utility-traction
joystick to change the direction and speed of the machine
(Figure
14). The further you move the joystick in either
direction, the faster the machine will move in the selected
direction.
18
(Figure
11). The 4 key-switch
Figure 13
2. Toe pedal (forward)
Advertisement
Table of Contents
