Table of Contents
Advertisement
Controls
Become familiar with all the controls
16) before you start the engine and operate the machine.
Command Center
Home Screen Controls
Use the buttons on the command center to control the
operation of machine functions, and to navigate to the
machine setup and diagnostic screens
Home screen shown
1. Button 1 (light On/Off
button—used with the light
kit option)
2. Button 2 (increase the
set point for the load
control—used with the
load-control kit)
3. Button 3 (decrease the
set point for the load
control—used with the
load-control kit)
4. Button 4 (load control
On/Off—used with the
load-control option)
5. Button 5 (control
select—use to determine
which attachment the
backfill-blade/vibratory-plow
joystick operates)
6. Button 6
(advanced-steering
mode—used with the
advanced-steering kit)
7. Button 7 (increase the
engine speed)
(Figure 9
through
(Figure
9).
Figure 9
8. Button 8 (decrease the
engine speed)
9. Escape (used to return to
the home screen)
10. Previous screen (used to
move to a previous screen
function within a screen
mode)
11. OK (used to make a
selection)
12. Next screen (used to move
to the next screen function
within a screen mode)
13. Down screen (used to
move down to the previous
screen mode and enter
diagnostic and calibration
screens)
14. Up screen (used to move
up the next screen mode)
Throttle Button
•
Throttle-up Button—Press the throttle-up button
Figure
(button 7), located at the bottom-right corner of the
command center, to increase the engine speed
Note: Press the button repeatedly to increase the engine
speed up to the maximum engine speed (2,450 rpm).
•
Throttle-down Button—Press the throttle-down button
(button 8), located at the bottom-right corner of the
command center, to lower the engine speed
Note: Press the button repeatedly to decrease the engine
speed down to the engine-idle speed (950 rpm).
Machine Controls
Differential-Lock Switch
Use the differential-lock switch to control the transmission of
power to all 4 wheels
•
To lock the front and rear differentials—push the switch
up.
•
To unlock the front and read differentials—stop the
machine, push the switch down, and move the machine
backward for a short distance.
1. Differential-lock switch
Parking-Brake Switch
•
Set the parking brake by pushing down the parking-brake
switch
(Figure
17
(Figure
10).
Figure 10
2. Horn button
11).
(Figure
9).
(Figure
9).
Advertisement
Table of Contents
