Product Overview; Controls - Toro 03781TE Operator's Manual

Product Overview

Controls

Brake Pedals
The 2 foot pedals (Figure
brakes for turning assistance and to aid in obtaining
better side hill traction.
Pedal-Locking Latch
The pedal-locking latch
pedals together to engage the parking brake.
Parking-Brake Pedal
To engage the parking brake,
pedals together with the pedal-locking latch, push
down on the right brake pedal while engaging the toe
pedal. To release the parking brake, press 1 of the
brake pedals until the parking-brake latch retracts.
Figure 25
1. Brake pedal
2. Pedal-locking latch
3. Parking-brake pedal
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move backward. Ground
speed is determined by how far you press the pedal.
For maximum ground speed, fully press the pedal
while the throttle is in the
To stop the machine, reduce your foot pressure on
the traction pedal and allow it to return to the center
position.
25) operate individual wheel
(Figure 25) connects the
(Figure 25) connect the
4. Traction pedal
5. Tilt-steering pedal
25) controls forward and
position.
FAST
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 25) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Mow-Speed Limiter
When the mow-speed limiter
it will control the mow speed and allow the cutting
units to be engaged. Each spacer adjusts the mowing
speed by 0.8 km/h (0.5 mph). The more spacers
that there are on the top of the bolt, the slower the
machine moves. To transport the machine, flip back
the mow-speed limiter for maximum transport speed.
Speed-Limiter Screws
Adjust the screw(s)
you can press the traction pedal forward or reverse to
limit the speed.
Important:
The speed-limiter screw must stop the
traction pedal before the pump reaches full stroke;
otherwise, damage to the pump may occur.
g015074
1. Reverse speed limiter
screw
2. Forward speed limiter
screw
Lower Mow/Raise Control Lever
This lever (Figure
units and also starts and stops the reels when you
enable the reels in the mow mode. You cannot lower
the cutting units when the mow/transport lever is in
the transport position.
Key Switch
The key switch
O /P , and S
N REHEAT
20
(Figure 26) is flipped up
(Figure 26) to limit the amount that
Figure 26
3. Spacers
4. Mow speed limiter
27) raises and lowers the cutting
(Figure 27) has 3 positions: O
.
TART
g015075
,
FF