Toro 03781TE Operator's Manual page 58

Use Toro replacement filters Part No. 94-2621 for
the rear (cutting unit) of the machine and Part No.
75-1310 for the front (charge) of the machine.
Important:
Using another type of filter may void
the warranty on some components.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Clean the area around the filter mounting area.
3. Place a drain pan under the filter and remove
the filter (Figure 81
4. Lubricate the new filter gasket and fill the filter
with hydraulic fluid.
1. Hydraulic filter
and Figure 82).
Figure 81
1. Hydraulic filter
5. Ensure that the filter mounting area is clean.
6. Screw the filter on until the gasket contacts
the mounting plate; then tighten the filter an
additional 1/2 turn.
g009723
7. Start the engine and let it run for about 2 minutes
to purge air from the system.
8. Shut off the engine and check for leaks.
58
Figure 82
g200374