Table of Contents
Advertisement
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
Backlap
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Rear Backlap Reel Speed
Protected Menus
Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit
Indicates the inputs, qualifiers,
and outputs for starting the
engine
Indicates the inputs, qualifiers,
and outputs for operating the
backlap function
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Controls the speed of the front
reels in backlap mode
Controls the speed of the rear
reels in backlap mode
Allows the
superintendant/mechanic
to access protected menus by
inputting a passcode
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary
Controls the number of blades
on the reel for reel speed
Controls the ground speed for
determining the reel speed
Controls the height of cut
(HOC) for determining the reel
speed
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted
*Only operator-faced text is translated. Faults,
Service, and Diagnostics screens are service-faced.
Titles are in the selected language, but menu items
are in English.
Protected under Protected Menus—accessible only
by entering PIN
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 5 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
Blade Count, Mow Speed, Height of Cut (HOC), F
Reel RPM, and R Reel RPM. You can lock these
settings by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing the Protected Menu
Settings
1.
From the Main Menu, scroll down to the Settings
Menu and press the right button.
2.
In the Settings Menu, scroll down to the
Protected Menu and press the right button.
3.
To enter the passcode, use the center button to
set the first digit then press the right button to
move on to the next digit.
4.
Use the center button to set the second digit
then press the right button to move on to the
next digit.
5.
Use the center button to set the third digit then
press the right button to move on to the next
digit.
6.
Use the center button to set the fourth digit then
press the right button.
7.
Press the middle button to enter the code.
8.
If the code has been accepted and the protected
menu has been "Unlocked", "PIN" displays in
the upper right corner of the display screen.
25
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
Advertisement
Chapters
Table of Contents
