Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro 03781TE Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.

Maintenance Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage the cutting unit(s) and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key (if
equipped).
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Maintenance Procedure
• Torque the wheel nuts.
• Change the front planetary-gear oil.
• Change the oil in the rear axle.
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the interlock switches.
• Check the level of the engine oil.
• Drain water or other contaminants from the water separator.
• Check the tire pressure.
• Visually inspect the rear axle for leaks.
• Visually inspect the gear box in the rear axle for leaks.
• Check the cooling system.
• Remove debris from the engine area, oil cooler, and radiator.
• Check the hydraulic lines and hoses.
• Check the level of the hydraulic fluid.
• Grease the bearings and bushings.
• Check the battery condition.
• Check the condition and tension of the alternator belt.
• Torque the wheel nuts.
• Change the engine oil and filter.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
36