Product Overview; Controls - Toro Reelmaster 03781 Operator's Manual

Product Overview

Controls

Brake Pedals
The 2 foot pedals (Figure
for turning assistance and to aid in obtaining better side hill
traction.
Pedal-Locking Latch
The pedal-locking latch (Figure
together to engage the parking brake.
Parking-Brake Pedal
To engage the parking brake,
together with the pedal-locking latch, push down on the
right brake pedal while engaging the toe pedal. To release
the parking brake, press 1 of the brake pedals until the
parking-brake latch retracts.
Figure 25
1. Brake pedal
2. Pedal-locking latch
3. Parking-brake pedal
Traction Pedal
The traction pedal (Figure
operation. Press the top of the pedal to move forward and
the bottom to move backward. Ground speed is determined
by how far you press the pedal. For maximum ground speed,
fully press the pedal while the throttle is in the
To stop the machine, reduce your foot pressure on the
traction pedal and allow it to return to the center position.
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot pedal
(Figure 25) down, and pull the steering tower toward you to
the most comfortable position and then release the pedal.
25) operate individual wheel brakes
25) connects the pedals
(Figure 25) connect the pedals
4. Traction pedal
5. Tilt-steering pedal
25) controls forward and reverse
FAST
Mow-Speed Limiter
When the mow-speed limiter
control the mow speed and allow the cutting units to be
engaged. Each spacer adjusts the mowing speed by 0.8 km/h
(½ mile per hour). The more spacers that there are on the
top of the bolt, the slower the machine goes. For transport,
flip back the mow-speed limiter and the machine will have
maximum transport speed.
Speed-Limiter Screws
Adjust the screw(s)
traction pedal can be pressed in the forward or reverse
direction to limit speed.
Important: The speed-limiter screw must stop the
traction pedal before the pump reaches full stroke or
damage to the pump may occur.
1. Reverse speed limiter
screw
2. Forward speed limiter
screw
g015074
Lower Mow/Raise Control Lever
This lever (Figure
also starts and stops the reels when the reels are enabled in
the mow mode. The cutting units cannot be lowered when
the mow/transport lever is in the transport position.
Key Switch
The key switch
O /P
N REHEAT
position.
InfoCenter
The InfoCenter LCD display shows information about your
machine such as the operating status, various diagnostics and
other information about the machine
PTO Switch
The PTO switch
Push the PTO button forward to engage the cutting-unit
19
(Figure 26) is flipped up it will
(Figure 26) to limit the amount the
Figure 26
3. Spacers
4. Mow speed limiter
27) raises and lowers the cutting units and
(Figure 27) has 3 positions: O
, and S .
TART
(Figure
(Figure 27) has 2 positions: S
g015075
,
FF
27).
and S .
TART TOP