1
Adjusting the Support Rollers
No Parts Required
Procedure
Depending on what width cutting units are to be installed on
the traction unit, adjust the support rollers as follows:
Park the machine on a level surface, engage the parking brake,
shut off the engine, and remove the key.
•
If using 27 inch cutting units, install the rollers in the
upper mounting holes of the support assembly channels
(Figure
3).
•
If using 32 inch cutting units, install the rollers in the
lower mounting holes of support assembly channels
(Figure
3).
1
1. Support assembly channel 3. Use this hole for 32 inch
2. Use this hole for 27 inch
cutting units.
2
g019541
3
Figure 3
cutting units.
2
Replacing the Warning Decal
for CE Compliance
Parts needed for this procedure:
1
Warning decal
Procedure
On machines requiring CE Compliance, affix the CE warning
decal (Part No. 120-1686) over the standard warning decal
(Part No. 120-1683).
3
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1
Hood-lock bracket
2
Rivet
1
Screw (1/4 x 2 inch)
2
Flat washer (1/4 inch)
1
Locknut (1/4 inch)
Procedure
g019541
1. Unhook the hood latch from the hood-latch bracket
(Figure
4).
11