2
Adjusting the Control-Arm
Position
No Parts Required
Procedure
The control-arm position can be adjusted for your
comfort.
1.
Loosen the 2 bolts securing the control arm to
the retaining bracket
1. Control arm
2. Retaining brackets
2.
Rotate the control arm to the desired position
and tighten the 2 bolts.
(Figure
3).
Figure 3
3. Bolts (2)
3
Installing the Cutting Units
Parts needed for this procedure:
1
Right front hose guide
1
Left front hose guide
Preparing the Machine
1.
Remove the reel motors from the shipping
brackets.
2.
Remove and discard the shipping brackets.
3.
At each cutting unit lift arm, remove the lynch pin
that secures the cap to the lift arm pivot yoke,
and remove the cap
1. Lynch pin
g004152
Preparing the Cutting Units
1.
Remove the cutting units from the cartons.
2.
Assemble and adjust as described in the cutting
unit Operator's Manual.
3.
Make sure that the counterweight
installed at the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
11
(Figure
4).
Figure 4
2. Cap
(Figure
g003975
5) is