Toro Reelmaster 5610 Operator's Manual page 28

PTO
Engine Run
Backlap
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Rear Backlap Reel Speed
Protected Menus
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
* Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced".
Titles are be in the selected language, but menu items
are in English.
About
Menu Item
Model
SN
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Indicates the inputs, qualifiers
and outputs for operating the
backlap function.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Controls the speed of the front
reels in backlap mode.
Controls the speed of the rear
reels in backlap mode.
Allows the
superintendant/mechanic
to access protected menus by
inputting a passcode.
Controls the number of blades
on the reel for reel speed.
Controls the ground speed for
determining the reel speed.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 5 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
Blade Count, Mow Speed, Height of Cut (HOC), F
Reel RPM and R Reel RPM. These settings can be
locked by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing the Protected Menu
Settings
To access the Protected Menu Settings
•
From the Main Menu, scroll down to the Settings
Menu and press the right button.
•
In the Settings Menu, scroll down to the Protected
Menu and press the right button.
•
To enter the passcode, use the center button to set
the first digit then press the right button to move
on to the next digit.
•
Use the center button to set the second digit then
press the right button to move on to the next digit.
•
Use the center button to set the third digit then
press the right button to move on to the next digit.
•
Use the center button to set the fourth digit then
press the right button.
•
Press the middle button to enter the code.
•
If the code has been accepted and the protected
menu has been "Unlocked," "PIN" will be displayed
in the upper right corner of the display screen.
The ability to view and change the settings in the
Protected Menu can be changed. Once you have
accessed the Protected Menu, scroll down to Protect
Settings. Using the right button, changing Protect
Settings to Off allows you to view and change the
settings in the Protected Menu without entering the
passcode. Changing Protect Settings to On hides the
protected options and requires entering a passcode
to change the setting in the Protected Menu. After
the pass code has been set, the key switch must be
turned off and back on to enable and save this feature.
Note:
If the passcode has been forgotten or
misplaced, please contact your distributor for
assistance.
28
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.