Toro Reelmaster 5610 Operator's Manual page 16

Figure 21
1. Turf-compensator bracket
2. Carriage bolt (3/8 x 1-1/4
inches)
6. Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
Installing the Kickstand
For each cutting unit, secure the kickstand to the
chain bracket with the snapper pin
Figure 22
1. Chain bracket
2. Snapper pin
g378789
3. Flange locknut (3/8 inch)
4. Inboard
(Figure 22).
g004144
3. Cutting-unit kickstand
Installing the Front Cutting Units
to the Lift Arms
1. Slide a cutting unit under the lift arm
1. Cap
2. Snapper pin
2. Assemble the lift-arm yoke onto the carrier
frame shaft.
3. Assemble the cap to the pivot-arm shaft, and
align the holes in the carrier frame shaft, pivot
arm shaft, and cap.
4. Secure the cap and the carrier-frame shaft to
the lift-arm yoke with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the lift-arm pivot shaft
24) to lock the cutting unit. Use the slot for a
steering cutting unit.
1. Snap-pin positions
2. Hole (lift-arm pivot shaft)
16
(Figure
Figure 23
3. Lift-arm yoke
4. Carrier frame shaft
(Figure
Figure 24
3. Slot (lift-arm pivot shaft)
23).
g375274
g375251