Toro Reelmaster 5610 Operator's Manual page 17

Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1. Slide a cutting unit under the lift arm
Figure 25
1. Cap
2. Snapper pin
2. Assemble the lift-arm yoke onto the carrier
frame shaft.
3. Assemble the cap to the pivot-arm shaft, and
align the holes in the carrier frame shaft, pivot
arm shaft, and cap.
4. Secure the pivot arm shaft and cap to the carrier
frame shaft with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the lift-arm pivot shaft
25) to lock the cutting unit. Use the slot for a
steering cutting unit.
(Figure 25).
g375252
3. Lift-arm yoke
4. Carrier frame shaft
(Figure
1. Snap-pin positions
2. Hole (lift-arm pivot shaft)
5. Repeat steps
unit.
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Lower Height of Cut
1. Remove the lynch pin and washer securing the
to the lift-arm pivot shaft to the lift arm, and slide
the pivot shaft out of the lift arm
1. Lift-arm pivot shaft 4.
2. Lift-arm pivot shaft
2. Assemble the lift-arm yoke onto the carrier
frame shaft (Figure
17
Figure 26
3. Slot (lift-arm pivot shaft)
1 and 2 for the other rear cutting
(Figure
Figure 27
3. Lift arm (rear cutting unit)
4. Washer
28).
g375251
27).
g375236