Chassis Maintenance; Inspecting The Seat Belt - Toro Reelmaster 5610 Operator's Manual
Traction unit
Hide thumbs
Also See for Reelmaster 5610:
- Owner's/operator's manual (56 pages) ,
- Service manual (662 pages) ,
- Operator's manual (60 pages)
Table of Contents
Advertisement
Figure 107
4.
Lower and latch the operator's seat; refer to
Lowering the Seat (page
5.
Wash all lapping compound off from the cutting
units.
6.
For a better cutting edge, run a file across the
front face of the bedknife after lapping.
Note:
This removes any burrs or rough edges
that may have built up on the cutting edge.
g377117
41).
Chassis Maintenance
Inspecting the Seat Belt
Service Interval: Before each use or daily
1.
Inspect the seat belt for wear, cuts, and other
damage. Replace the seat belt(s) if any
component does not operate properly.
2.
Clean the seat belt as necessary.
63
Advertisement
Table of Contents
