Backlapping the Cutting Units (continued)
2. Wash all lapping compound off of the cutting units.
3. Adjust the cutting unit reel-to-bedknife as needed.
4. Rotate the backlap levers to the F (mow) position.
Backlap lever (front cutting units 4, 1, and 5)
Backlap lever (rear cutting units 2 and 3)
5. For a better cutting edge, run a file across the front face of the bedknife after lapping.
Note:
edge.
6. Close and latch the hood.
Chassis Maintenance
Inspecting the Seat Belt
1. Inspect the seat belt for wear, cuts, and other damage. Replace the seat belt(s) if any
component does not operate properly.
2. Clean the seat belt as necessary.
Maintenance: Chassis Maintenance
This removes any burrs or rough edges that may have built up on the cutting
G425519
Forward rotation (mow)
Page 6–52
3466-702 A