Adjusting The Traction Drive For Neutral - Toro Reelmaster 7000-D Operator's Manual

Adjusting Maximum Mow-Ground Speed (continued)
5. In the Settings Menu, press the middle button until the Mow Speed option is
highlighted, and press the right button.
6. In the Mow Speed screen, press the middle button or the right button until the mow
speed shown in the display is the same as the maximum mow-ground speed that you
previously determined.
Note:
Note:
displays.
7. Press the left button to exit the Settings Menu.

Adjusting the Traction Drive for Neutral

The machine must not move forward or backward when you release the traction pedal. If the
machine moves, adjust the traction drive for neutral.
1. Park the machine on a level surface, shut off the engine, position the speed control into
the low range, and lower the cutting units.
2. Press only the right brake pedal and engage the parking brake.
3. Jack up the left side of the machine until the left front tire is off the ground. Support the
machine with jack stands to prevent it from falling accidentally.
4. Start the engine and allow it run at low idle.
5. Adjust the jam nuts on the rod end to move the traction rod forward to eliminate forward
creep or rearward to eliminate rearward creep .
3466-702A
The mow speed setting increases or decreases in 0.8 kph (0.5 mph) increments.
The indicator light illuminates and Advisory #176 (Reel Speed Changed)
G425373
G425374
Page 6–35 Maintenance: Drive System Maintenance