Changing The Planetary-Gear-Drive Oil - Toro Reelmaster 7000-D Operator's Manual

Checking the Planetary Gear-Drive Lubricant (continued)
2. Remove the check plug
position.
Note:
the check-plug hole
3. If the oil level is low, remove the fill plug at the
12 o'clock position and add oil until it begins to
flow out of the hole at the 3 o'clock position.
4. Check the O-ring for the plug(s) for wear or
damage.
Note:
5. Install the plug(s).
6. Repeat this procedure on the planetary gear assembly at the other side of the machine.

Changing the Planetary-Gear-Drive Oil

Lubricant specification: high quality SAE 85W-140 gear oil
Planetary and brake housing lubrication capacity: 0.65 L (22 fl oz)
Draining the Planetary-Gear-Drive
1. Park the machine on level surface, position the wheel so that the fill plug is at the 12
o'clock position, the check plug is at 3 o'clock position, and the drain plug is at the 6
o'clock position..
2. Remove the fill plug at the 12 o'clock position and the check plug at the 3 o'clock
position.
Drain-plug hole
Fill plug
3. Place a drain pan under the planetary hub, remove the drain plug at the 6 o'clock
position, and allow the oil to fully drain.
3466-702A
at the 3 o'clock
The oil level should be at the bottom of
.
Replace the O-ring(s) as needed.
G425185
G425192
Check plug
Drain plug
Page 6–29 Maintenance: Drive System Maintenance