Replacing The Water-Separator Filter - Toro Reelmaster 7000-D Operator's Manual

Draining the Fuel/Water Separator (continued)
3. Start the engine, check for leaks, and shut off the engine.
Note:

Replacing the Water-Separator Filter

1. Fully drain the fuel-water separator.
2. Clean the filter head
3. Remove the filter canister, and clean the
mounting surface of the filter head.
4. Lubricate the gasket on the filter canister with
clean fuel.
5. Install the filter canister by hand until the
gasket contacts the mounting surface, then
rotate it an additional 1/2 turn.
6. Tighten the drain valve at the bottom of the
filter canister.
7. Start the engine and check for leaks.
Note:
8. Shut off the engine and remove the key.
9. Close and latch the hood.
3466-702A
Repair all fuel leaks.
and filter canister
Repair all leaks.
G452998
.
G425089
Page 6–21 Maintenance: Fuel System Maintenance