Toro Reelmaster 5610 Operator's Manual page 18

Figure 28
1. Cap
2. Snapper pin
3. Assemble the cap to the pivot-arm shaft, and
align the holes in the carrier frame shaft, pivot
arm shaft, and cap.
4. Secure the pivot arm shaft and cap to the carrier
frame shaft with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the lift-arm pivot shaft
29) to lock the cutting unit. Use the slot for a
steering cutting unit.
Figure 29
1. Snap-pin positions
2. Hole (lift-arm pivot shaft)
5. Slide a cutting unit under the lift arm
g375237
3. Lift-arm yoke
4. Carrier frame shaft
(Figure
g375251
3. Slot (lift-arm pivot shaft)
(Figure 30).
1. Lynch pin
2. Lift-arm shaft
6. Insert the lift-arm shaft into the lift arm, and
secure shaft to the arm with the lynch pin and
washer.
7. Repeat steps
cutting unit.
Installing the Cutting Unit Lift-Arm
Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin (Figure
Note:
Use the number of chain links described in the
cutting unit Operator's Manual.
1. Lift-arm chain
2. Chain bracket
Installing the Reel Motors
1. Coat the spline shaft of the reel motor with clean
grease.
2. Oil the reel motor O-ring and install it onto the
motor flange.
3. Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
18
Figure 30
3. Lift arm
4. Washer
1 through 6 for the other rear
31).
Figure 31
3. Snapper pin
(Figure
g375239
g003948
32).