Toro Reelmaster 03781 Operator's Manual page 24

Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 5 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter: Blade
Count, Mow Speed, Height of Cut (HOC), F Reel RPM,
and R Reel RPM. These settings can be locked by using the
Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
1. From the Main Menu, scroll down to the Settings
Menu and press the right button.
2. In the Settings Menu, scroll down to the Protected
Menu and press the right button.
3. To enter the passcode, use the center button to set
the first digit then press the right button to move on
to the next digit.
4. Use the center button to set the second digit then press
the right button to move on to the next digit.
5. Use the center button to set the third digit then press
the right button to move on to the next digit.
6. Use the center button to set the fourth digit then press
the right button.
7. Press the middle button to enter the code.
8. If the code has been accepted and the protected menu
has been "Unlocked", "PIN" will be displayed in the
upper right corner of the display screen.
The ability to view and change the settings in the Protected
Menu can be changed. Once the Protected Menu has been
accessed, scroll down to Protect Settings. Using the right
button, changing Protect Settings to Off will allow the ability
to view and change the settings in the Protected Menu
without entering the passcode. Changing Protect Settings to
On will hide the protected options and will require entering a
passcode to change the setting in the Protected Menu. After
the pass code has been set, the key switch must be turned off
and back on to enable and save this feature.
Note: If the passcode has been forgotten or misplaced,
please contact your distributor for assistance.
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
2. Press the right button to change the auto idle time
between Off, 8S, 10S, 15S, 20S, and 30S.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count
2. Press the right button to change the Blade Count
between 5, 8, or 11 blades.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the appropriate
mow speed set on the mechanical mow-speed limiter
on the traction pedal.
4. Press the left button to exit mow speed and save the
setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the appropriate
HOC setting.
Note: If the exact setting is not displayed, select the
nearest HOC setting from the list displayed.
4. Press the left button to exit HOC and save the setting.
24