Toro Reelmaster 03781 Operator's Manual page 15

Figure 15
1. Hex-socket screw
2. Pivot spacer
8. Lower all of the lift arms completely.
9. Coat the carrier-frame shaft with clean grease
16).
1
5
4
Figure 16
1. Lift-arm pivot yoke
2. Lift arm
3. Klik pin
3. Carrier frame
4. Flange locknut
3
G015976
4. Carrier-frame shaft
5. Thrust washer
10. For the front cutting units, slide a cutting unit under
the lift arm while inserting the shaft of the carrier
frame up into the lift-arm pivot yoke
sure that the thrust washer is in position on the carrier
frame shaft.
11. Secure the carrier-frame shaft to the lift-arm yoke with
the klik pin
12. To lock (fix) the steering on the cutting units, secure
the pivot yoke to the carrier frame with the snapper
pin (Figure
g033150
1
(Figure
1. Snapper pin
Note: Fixed steering is recommended when
cutting on side hills.
13. Use the following procedure on the rear cutting units
when the height of cut is above 19 mm (3/4 inch).
2
A. Remove the lynch pin and washer securing the
lift-arm pivot shaft to the lift arm and slide the
lift-arm pivot shaft out of the lift arm
1. Lift-arm pivot-shaft lynch pin and washer
B. Insert the lift-arm yoke onto the carrier frame
shaft
g015976
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and the lynch pin
18).
14. Secure the lift-arm chain to the chain bracket with the
snapper pin
15
(Figure 16).
17).
G015977
Figure 17
Figure 18
(Figure 16).
(Figure 19).
(Figure 16). Make
g015977
(Figure 18).
g003979
(Figure