Checking The Cooling System - Toro Reelmaster 03781 Operator's Manual

Note: Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. See the
parts catalog for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it
has already been run, allow the oil to drain back down to
the sump for at least 10 minutes before checking. If the
oil level is at or below the Add mark on the dipstick, add
oil to bring the oil level to the Full mark. Do not overfill
the engine. If the oil level is between the Full and Add
marks, no oil addition is required.
1. Park the machine on a level surface.
2. Unlock the hood latches and open the hood
34).
Figure 34
1. Hood latch
3. Remove the dipstick, wipe it clean, install the dipstick
into the tube, and pull it out again.
The oil level should be in the safe range
(Figure
1. Dipstick
4. If the oil is below the safe range, remove the fill cap
g200373
(Figure 35).
1. Oil-fill cap
5. Install the oil fill cap and dipstick.
6. Close the hood and secure it with the latches.

Checking the Cooling System

Service Interval: Before each use or daily
Check the level of the coolant at the beginning of each day.
The capacity of the system is 12.3 L (13 US qt).
1. Carefully remove the radiator cap.
27
Figure 35
(Figure 36) and add oil until the level reaches the Full
mark.
Important: Do not overfill the engine.
Figure 36
Note: When using different oil, drain all old oil from
the crankcase before adding new oil.
g008808
g008809