Maintenance; Recommended Maintenance Schedule(S) - Toro Reelmaster 03781 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 800 hours
Before storage
Maintenance Procedure
• Torque the wheel nuts.
• Change the planetary gear drive oil.
• Change the oil in the rear axle.
• Change the hydraulic filters.
• Check the level of the engine oil.
• Check the cooling system.
• Check the level of the hydraulic fluid.
• Check the tire pressure.
• Check the interlock switches.
• Drain water or other contaminants from the water separator.
• Remove debris from the engine area, oil cooler, and radiator.
• Inspect the hydraulic lines and hoses for leaks, kinked lines, loose mounting
supports, wear, loose fittings, weather deterioration, and chemical deterioration.
• Grease the bearings and bushings.
• Check the battery condition.
• Check the condition and tension of the alternator belt.
• Torque the wheel nuts.
• Change the engine oil and filter.
• Service the air cleaner (Service the air cleaner earlier if the service indicator shows
red. Service it more frequently in extremely dirty or dusty conditions.).
• Check the fuel lines and connections for deterioration, damage, or loose connections.
• Replace the fuel filter canister.
• Check the oil level of the planetary gear drive (also, check for external leakage).
• Check the oil level of the rear axle.
• Check the lubricant in the gear box of the rear axle.
• Drain and clean the fuel tank.
• Change the planetary gear drive oil (or yearly, whichever comes first).
• Change the oil in the rear axle.
• Check the rear-wheel toe-in.
• Change the hydraulic fluid.
• Change the hydraulic filters.
• Drain and clean the fuel tank.
• Check the tire pressure.
• Check all fasteners.
• Grease or oil all grease fittings and pivot points.
• Paint chipped surfaces.
38