8
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the level of the rear axle lubricant before the
engine is first started, refer to
of the Rear Axle (page
2. Check the level of the hydraulic fluid before the engine
is first started, refer to
Hydraulic Fluid (page
3. Check the level of the engine oil before and after the
engine is first started, refer to
the Engine Oil (page
9
Using the Gauge Bar
Parts needed for this procedure:
1
Gauge bar
Procedure
Use the gauge bar to adjust the cutting unit. Refer to the
cutting unit Operator's Manual for the adjustment procedures
(Figure
24).
Checking the Oil Level
51).
Checking the Level of the
29).
Checking the Level of
26).
1. Gauge bar
2. Height-adjusting screw
3. Nut
18
Figure 24
4. Holes used for setting the
groomer height of groom
(HOG)
5. Hole not used
g004552