Checking The Hydraulic-Fluid Level; Checking The Restricted Air-Cleaner Indicator; Inspecting The Machine - Toro 25450A Operator's Manual

Checking the Hydraulic-Fluid
Level
Service Interval: Before each use or daily
Hydraulic fluid specification: Mobilfluid 424
Note: Many brands of hydraulic fluid are almost colorless,
making it difficult to detect leaks. A red dye additive for the
hydraulic system oil is available in 20 ml (0.68 oz) bottles.
One bottle is sufficient for 15.1 to 22.7 L (4.0 to 6.0 US
gal) of hydraulic fluid; you can order this additive from an
Authorized Toro Service Dealer.
1. Park the machine on a level surface, and put all the
attachments in the transport position.
2. Stop the engine, set the parking brake, and remove the
ignition key.
3. Check the hydraulic-fluid level in the sight glass located
at the side of the hydraulic reservoir
1. Fill cap (off)
2. Hydraulic fluid
Note: The hydraulic-fluid level should be between the
bottom and midpoint of the sight glass.
4. If the hydraulic-fluid level is not visible in the sight
glass, remove the fill cap
hydraulic fluid until the fluid level is at the midpoint of
the sight glass, and install the fill cap.
(Figure
Figure 27
3. Hydraulic fluid level at the
midpoint of the sight glass
(Figure 27), add the specified
Checking the Restricted
Air-Cleaner Indicator
Service Interval: Before each use or daily
1. Start the engine; refer to
34).
2. Check to see if the restricted air-cleaner indicator is
displayed in the home screen of the command center
(Figure
27).
1. Restricted air-cleaner
indicator
3. Replace the air-cleaner element(s) as follows:
A. Replace the primary air-cleaner element; refer to
B. Repeat steps
C. If the restricted air-cleaner indicator is still

Inspecting the Machine

Service Interval: Before each use or daily
Inspect the following items on the machine each day before
you start the engine:
•
Check for leaks under the machine, and repair all leaks.
•
Check the tires for wear, damage, and low pressure.
•
Check the machine for debris, especially around the
engine.
Note: Ensure that the area near the engine is clean so
that the engine cools properly.
•
Clean or replace any safety or instructional decal that you
cannot read.
•
Clean machine components that you use.
•
Remove any loose items from the machine.
27
Operating the Engine (page
28).
Figure 28
2. Command center
Replacing the Air-cleaner Elements (page
1 and 2.
displayed, replace the secondary air-cleaner
element; refer to Replacing the Air-cleaner
Elements (page 50).
50).