Table of Contents
Advertisement
•
Check the machine for broken, damaged, loose, or
missing parts. Replace, tighten, or adjust these parts
before you operate the machine.
•
Repair or replace all damaged ROPS and seat belt parts.
Operating the Command
Center
Software Messages
The command center will display information about the
controller version, display version, and installed optional
attachments or kits that are operated through the command
center. This information is displayed on the splash screen
during start up of the machine, as shown in A of
or when you access the main selection screen, as shown in B
of
Figure
29.
1. Main controller version
2. Display version
Using the Home Screen
Use the previous screen, next screen, down screen, or up
screen buttons to display either the rpm home screen (A of
Figure
30), the % load home screen (B of
main selection screen (C of
Figure 29
Figure 29
3. Installed optional
attachments or kits
Figure
30) or the
Figure
30).
1. Previous screen button
2. Next screen button
Understand the meaning of the icons that indicate the
functions and the state of the machine.
28
Figure 30
3. Down screen button
4. Up screen button
Advertisement
Table of Contents
