Table of Contents
Advertisement
1. Gear indicator
2. Parking brake indicator
3. Tachometer
4. Machine or engine error
5. Low engine-oil pressure
Reading the Operating Indicators in the Command
Display
Display the home screen of the command center to find
information about the transmission, engine, hydraulic system,
and fuel quantity.
•
Gear indicator—This indicator shows which gear is
selected for the transmission (gears 1 through 4) and is
displayed above and to the left of tachometer
•
Tachometer—The tachometer indicates the engine
speed in revolutions per minute (rpm). The tachometer
is displayed in the upper center of the command-center
display
(Figure
31).
Note: Each number on the gauge is equal to x 100 rpm.
Each space on the gauge is equal to 600 rpm. The range
of the tachometer display is 0 to 3000 rpm.
•
Hour meter—The hour meter indicates the number
of hours that the engine has run. It is displayed in the
center right area of the command display, to the right of
the tachometer
(Figure
•
Hydraulic-fluid temperature indicator—This indicator
shows the operating temperature of the hydraulic fluid
and is displayed in the lower left area of the command
display
(Figure
31).
Note: If the indicator moves into the red area, reduce
the work speed. If the gauge remains in the red area, stop
the machine and move the direction control lever to the
Neutral position. Check the oil level and for obstructions
in the radiator or the oil cooler.
•
Coolant temperature indicator—This indicator shows
the temperature of the coolant in the engine-cooling
system. It is displayed in the lower center area of the
instrument cluster
(Figure
Figure 31
6. Check alternator or battery
7. Hour meter
8. Hydraulic-fluid
temperature
9. Coolant temperature
10. Fuel level
(Figure
31).
31).
Note: If the indicator goes into the red area, reduce
the engine speed to idle for a few minutes to allow the
engine to cool, then stop the engine. Check the coolant
level, for debris on the radiator, or for a thermostat that
does not operate correctly. Also check the drive belt, belt
tensioner, or water-pump pulley.
•
Fuel-level indicator—This indicator shows the
remaining level of fuel that is in the tank, and it is
displayed in the lower right area of the command display
(Figure
31).
•
Parking-brake-on indicator—This indicator is
displayed while the parking brake is engaged
The indicator disappears when you release the parking
brake.
Changing Units of Measure
Use this procedure to change from English to metric units or
from metric to English units
1. Display the home screen of the command center
(Figure
32).
31).
1. Left+right+up buttons
2. Press the left+right+up buttons
Note: The units of measure should change from
English to metric units or from metric to English units.
Note: If the display changes from the home screen to
the main selection screen, press the left, right, up, or
down button to return to the home screen.
Reading the Warning Messages in the Command
Display
Note: When there are warning messages in the command
display, take corrective measures immediately. There may be
more than 1 warning displayed.
29
(Figure
Figure 32
(Figure
32).
31).
Advertisement
Table of Contents
