Checking The Coolant Level In The Reservoir - Toro 25450A Operator's Manual

Figure 24
1. Dipstick
Figure 25
5. Insert the dipstick fully into the dipstick tube, then
remove the dipstick (Figure
6. Read the oil level on the dipstick
Note: The oil level on the dipstick should be between
the H (high) mark and L (low) mark.
•
If the oil level is too low, slowly pour a small
amount of the specified oil into the oil-filler neck
(Figure 70) and wait 3 minutes; refer to step
Filling the Engine with Oil (page
Important: Do not overfill the engine with oil.
•
If the oil level is too high, drain the excess oil until
you obtain the correct oil level on the dipstick;
refer to Draining the Engine Oil (page
7. Repeat steps 4 through
8. Install the dipstick and oil-fill cap securely.
9. Install the left-side panel; refer to
Panels (page 47).
2. Dipstick tube
24).
(Figure 25).
1
49).
48).
6 until the oil level is correct.
Installing the Side
Checking the Coolant Level in
the Reservoir
Service Interval: Before each use or daily
If the engine overheat warning is displayed on the control
panel, check the coolant level in the reservoir and add coolant
if it is low. Also inspect the engine compartment around the
radiator and clear away any obstructions to air flow.
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Allow the engine to cool.
3. Remove the left side panel; refer to
Panels (page
4. Check the coolant level in the reservoir
1
2
g024979
1. Reservoir
Note: Ensure that the coolant level is between 1/4
in
and 3/4 of the way up in the sight glass
5. Add the specified coolant until the coolant level is
between 1/4 and 3/4 of the way up in the sight glass.
Note: Ensure that the coolant solution is thoroughly
mixed before filling the reservoir.
6. Install the left side panel; refer to
Panels (page
26
Removing the Side
46).
Figure 26
2. Coolant level (halfway
between the Add and Full
marks)
Installing the Side
47).
(Figure 26).
(Figure 26).