Table of Contents
Advertisement
Figure 122
1. Charge wire
2. Boot
2. Remove the nut and washer that secures the terminal
of the charge wire to the stud of the alternator, and
remove the terminal.
3. Remove the 4-socket connector for the voltage-sense
wire from the 4-pin connector on top of the alternator
(Figure
122).
Disconnecting the
Computer-module Connectors
1. Remove the 4 hex-flanged head bolts (6 x 20 mm) that
secure the lower-console panel to the console, and
remove the panel
(Figure
Figure 123
1. Lower-console panel
3. 4-socket connector
(voltage-sense wire)
123).
2. Hex-flanged head bolts (6
x 20 mm)
2. Disconnect the 50-socket connector (CPU 1) from the
back of the computer module
1. Forward
2. 50-socket connector (CPU
1)
3. Disconnect the 38-socket connector (CPU-2) from the
back of the computer module
Connecting the
Computer-module Connectors
1. Connect the 38-socket connector (CPU-2) to the back
of the computer module
2. Connect the 50-socket connector (CPU 1) to the back
of the computer module
3. Align the lower-console panel to the console
123).
4. Secure the panel to the console with the 4 hex-flanged
head bolts (6 x 20 mm).
Connecting the Alternator
Wiring
1. Ensure that the battery-disconnect switch is in the Off
position; refer to
2. Connect the 4-socket connector for the voltage-sense
wire to the 4-pin connector on top of the alternator
(Figure
122).
3. Assemble the terminal of the charge wire onto the stud
at the back of the alternator
4. Secure the charge wire to the stud with the nut and
washer.
76
(Figure
124).
Figure 124
3. Computer module
4. 38-socket connector
(CPU-2)
(Figure
124).
(Figure
124).
(Figure
124).
Battery-Disconnect Switch (page
(Figure
122).
(Figure
21).
Advertisement
Table of Contents
