Toro 25450A Operator's Manual page 33

Figure 41
1. Decrease the range of
ground speed set with the
utility-traction joystick
2. Percent setting (50%
shown)
2. Set the ground speed limit for the utility-traction
joystick as follows:
•
Press button 3 (Figure
of ground speed that you can set with the
utility-traction joystick (down to 15% of the ground
speed that you can set with the foot pedal.).
Note: This gives you finer control over a smaller
range of ground speed.
•
Press button 7 (Figure
of ground speed that you can set with the
utility-traction joystick.
Note: This gives you courser control over a larger
range of ground speed (up to 100% of the ground
speed that you can set with the foot pedal.
3. Press button 8 to save your setting
Note: The save icon momentarily displays the word
Save and turns green.
3. Save setting
4. Increase the range of
ground speed set with the
utility-traction joystick
41) to lower the percent
41) to increase the percent
(Figure 41).
Using the PIN screen
Note: This procedure requires that you have the PIN
number, which you can obtain from an Authorized Service
Dealer.
Note: To access the trencher setup function for the machine,
you must enter the unique 8-digit identification number
assigned into the PIN screen. The trencher setup functions
protected by the PIN screen include the following:
•
Pedal calibration
•
Steering setup
•
Auto-tilt setup
1. Press button number 2 [Trencher (traction unit) setup]
on the main-selection screen; refer to
Main-Selection Screen (page
2. Enter the 8-digit PIN.
3. Press button number 8 [Enter].
Note: Numbers 1, 2, 3, 5, 6, and 7 are the only numbers
that can be used for the PIN.
1. Buttons for corresponding
PIN numbers
2. PIN entry appears here
33
Accessing the
31).
Figure 42
3. Enter PIN
4. Return to the previous
screen