Table of Contents
Advertisement
Figure 21
1. Dipstick
3. Insert the dipstick fully into the dipstick tube, then
remove the dipstick
4. Read the oil level on the dipstick.
•
If the oil level is too low, slowly pour a small
amount of the specified oil into the oil-filler neck
(Figure
44), wait 3 minutes; refer to step
the Engine with Oil (page
•
If the oil level is too high, drain the excess oil until
you obtain the correct oil level on the dipstick;
refer to
Draining the Engine Oil (page
5. Repeat steps
2
through
6. Install the dipstick and oil-fill cap securely.
7. Install the right-side panel; refer to
Panels (page
37).
Checking the Hydraulic Fluid
Level
Service Interval: Before each use or daily
Use Toro Premium All-season Hydraulic Fluid (available
in 5-gallon pails or 55-gallon drums. See the parts catalog or
an Authorized Toro Service Dealer for part numbers).
If Toro hydraulic fluid is not available, you may use an
equivalent hydraulic fluid, provided that it meets all the
following material properties and industry specifications. Do
not use a synthetic hydraulic fluid. Consult with your
lubricant distributor to identify a satisfactory product.
High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
Viscosity Index ASTM
D2270
Pour Point, ASTM D97
2. Dipstick tube
(Figure
21).
1
40).
39).
4
until the oil level is correct.
Installing the Side
St @ 40°C (104°F): 44 to 48
St @ 100°C (212°F): 7.9 to 8.5
140 to 160
-37°C (-34°F) to -45°C (-49°F)
High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG 46 (cont'd.)
FZG, Fail stage
Water content (new fluid)
Industry Specifications:
Note: Many brands of hydraulic fluids are almost colorless,
making it difficult to spot leaks. A red dye additive for the
hydraulic system oil is available in 20 ml (0.68 oz) bottles.
One bottle is sufficient for 15.1 to 22.7 L (4.0 to 6.0 US gal)
of hydraulic oil. Order part no. 44-2500 from an Authorized
Toro Service Dealer.
1. Park the machine on a level surface, and put all the
attachments in the transport position.
2. Stop the engine, set the parking brake, and remove the
ignition key.
3. Check the hydraulic fluid level in the sight gauge
in
Filling
located at the side of the hydraulic reservoir
1. Fill level (midpoint)
2. Sight gauge
Note: The hydraulic fluid level should be between the
Add and Full marks on the sight gauge.
4. If the hydraulic fluid level is below the Add mark,
remove the fill cap/breather
24
11 or better
500 ppm (maximum)
Vickers I-286-S (Quality Level),
Vickers M-2950-S (Quality
Level), Denison HF-0
(Figure
Figure 22
3. Hydraulic fluid
(Figure
22), add the
22).
Advertisement
Table of Contents
