Toro 25430 Operator's Manual page 37

1. Side panel
2. Anchor bracket
3. Lift the side panel straight up and remove it from the
machine (Figure 36).
Installing the Side Panels
1. Align the left side panel with the left side of the
machine and the right side panel with the right side
of the machine.
2. Align the tabs at the top of the side panel with the
receiver brackets on the machine
1. Tab
2. Side panel
3. Lower the side panel straight down.
Note: Ensure that the tabs of the side panel align into
the receiver brackets on the machine.
4. Pull the hand grip of the panel latch outward, then pivot
it up until it aligns in the anchor bracket
5. Release the latch handle.
6. If the backhoe is installed on the machine, do the
following substeps:
Figure 36
3. Panel latch
(Figure 37).
Figure 37
3. Receiver brackets
(Figure
A. Rotate the front end of the walkway to its original
position
B. Align the hole in the walkway with the hole in the
walkway support bracket
C. Install the retaining pin through the holes.
Removing the Nose Panel
1. Remove both the left side panel and the right side
panel from the machine; refer to
Panels (page
2. If the backhoe is installed on the machine, do the
following substeps; otherwise, skip to step 3.
A. Remove the hairpin from the seat lock pin
38).
1. Hairpin
B. Remove the seat lock pin from the frame of the
backhoe and the seat post
C. Pivot the seat post upward, and insert the
seat-lock pin through the holes in the frame of
the backhoe to hold the seat up to make room for
removing the nose panel
Note: Install the seat lock pin and hairpin in the
backhoe frame to hold the seat up position.
3. Remove the 4 bolts at the bottom of the left and right
sides of the nose panel
36).
37
(Figure 35).
(Figure
Removing the Side
36).
Figure 38
2. Seat lock pin
(Figure
(Figure
(Figure 39).
35).
(Figure
38).
38).