Note: Ensure that the secondary element is fully
seated in the housing.
5. Insert the primary air-cleaner element into the air-filter
housing; refer to
Replacing the Primary Element (page
42).
Note: Ensure that the primary element is fully seated
in the housing.
6. Install the air-cleaner cover; refer to
Air-cleaner Cover (page
7. Check the restricted air-cleaner light; refer to
the Restricted Air-cleaner Light (page
Installing the
42).
Checking
41).
Fuel System
Maintenance
Servicing the Fuel System
Draining the Fuel-water Separator
Service Interval: Every 50 hours
1. Remove the left side panel; refer to
Panels (page
36).
2. Place a small drain pan under the secondary fuel filter
(Figure
52).
1. Secondary-fuel filter
3. Rotate the drain valve at the bottom of the secondary
fuel filter 2 or 3 turns counterclockwise, and drain any
water and sediment from the fuel-water separator of
the fuel filter
(Figure
Note: If the fuel-water separator has any water or
sediment, drain the water and sediment from the fuel
tank; go to step 2.
4. When clean fuel appears, rotate the drain valve
clockwise until it is closed
Note: Do not overtighten the drain valve.
5. Bleed the fuel system; refer to
(page
45).
6. Install the left side panel; refer to
Panels (page
37).
Draining Water from the Fuel Tank
1. Place a drain pan under the drain plug in the fuel tank.
2. Unscrew the drain plug from the fuel tank and drain
the water
(Figure
43
Removing the Side
Figure 52
2. Drain valve
52).
(Figure
52).
Bleeding the Fuel System
Installing the Side
53).