Toro 25430 Operator's Manual page 57

Figure 80
1. Drain hose
2. Drain valve
4. Open the drain valve on the radiator, and allow the
coolant to drain completely.
Note: Dispose of the used coolant properly according
to local codes.
5. Close the drain valve
Flushing the Cooling System
Engine and radiator coolant capacity: 17.2 liter (18.2 US
qt)
1. Condition the cooling system as follows:
A. Ensure that the coolant is drained from the
radiator and that the drain valve is closed.
B. Open the vent valve
C. Add a cooling system cleaning solution to the to
the radiator through the filler neck
Note: Use cleaning solution of sodium carbonate
and water (or a commercially available equivalent).
Follow the directions that come with the cleaning
solution.
3. Radiator shroud (lower-left
area)
(Figure 80).
(Figure 78).
(Figure
1. Coolant system cleaning
solution
2. Funnel
D. Close the vent valve.
Important: Do not install the radiator cap.
E. Operate the engine for 5 minutes or until the
coolant temperature gauge in the instrument
cluster indicates 82°C (180°F), then stop the
engine
The cleaning solution is hot and can
cause burns.
81).
Stay away from the discharge end of the
coolant drain hose.
F. Open the drain valve and drain the cleaning
solution into a drain pan
G. Close the drain valve.
2. Flush the cooling system as follows:
A. Open the vent valve
B. Fill the radiator with clean water
57
Figure 81
3. Filler neck (radiator)
(Figure 82).
Figure 82
CAUTION
(Figure
(Figure 78).
80).
(Figure 83).