Toro 25450 Operator's Manual page 57

Note: Before you add air, ensure that the tire is
properly installed on the machine, or put the wheel in a
restraining device, such as a tire inflation cage.
2. Remove the cap from the valve stem.
3. Attach the self-locking chuck of the air hose to the
valve stem.
4. When inflating the tire while it is mounted to the
machine, stand behind the tread of the tire.
Note: Ensure that all persons are away from the side
of the tire before you start to add air.
5. Open the remote shutoff valve to inflate the tire to the
specified pressure, then close the valve.
Important: Do not inflate the tire more than the
recommended pressure.
6. Remove the air chuck from the valve stem.
7. Install the cap on the valve stem.
Maintaining the Tires and Wheels
Always have a qualified tire technician service the tires and
wheels of this machine. To prevent accidents, use a restraining
device (such as a tire inflation cage), the correct equipment,
and the correct procedure.
Important: There are 2 different tire-tread pattern and
wheel combinations; the left-side tires and the right-side
tires are different. Ensure that the tread direction of the
tire and the valve stem in the wheel are correctly aligned
before installing the tire to the rim.
1. Left-side tire
2. Forward
Torquing the Wheel Nuts
1. Ensure that the mounting flange of the wheel is flush
against the mounting flange of the axle.
2. Incrementally torque the wheel nuts for each wheel
as follows:
A. Torque the all wheel nuts to 100 N-m (75 ft-lb) in
the sequence shown in
Figure 82
3. Right-side tire
4. Valve stem
Figure 83.
B. Torque all the nuts to 200 N-m (150 ft-lb) in the
sequence shown in
C. Torque all the nuts to 300 N-m (225 ft-lb) in the
sequence shown in
57
Figure 83
Figure 83.
Figure 83.