Yamaha Electone STAGEA ELC-02 Owner's Manual page 101

4
Select the targeted Registration
numbers and turn them on.
Parameters in Registrations set to ON will be changed.
Press the targeted Registration in the display and
turn it on with the SETTINGS buttons: ALL ON,
ALL OFF, ON, OFF, and SELECT.
ALL ON: Selects all Registration memory numbers.
ALL OFF: Cancels all Registration memory
numbers.
ON: Sets the currently selected Registration
memory number to "ON. "
OFF: Sets the currently selected Registration
memory number to "OFF. "
SELECT: Turns on the Registration memory
numbers that contain the same Voice as the one
which is currently set in the Registration at the
cursor position.
The targeted Registration numbers are underlined.
5
Unifies the currently turned-on
parameter's values.
You unify the relevant parameter values in each
Registration memory number or offset them. Keep
in mind that you cannot restore the original data
once you change the parameter's value.
Unifying Values/Settings of a Specific Parameter
Unifying the currently highlighted
parameter's value:
Pressing [SET] unifies the currently highlighted
parameter's values to the one in the currently selected
Registration (at the cursor position). A message appears
prompting you to confirm the operation.
To continue the operation, select [UNIFY]. Select
[CANCEL] to abort the operation.
Offsetting the currently highlighted
parameter's value:
Pressing the [+]/[-] buttons in the display or using the
Data Control dial offsets the currently highlighted
parameter's value. If you select Pan as the parameter, the
[L][R] buttons are shown instead of [+]/[-].
If you change the value, and if parameter values for some
Registration memory number reach the maximum or
minimum, the following message appears.
In this case, pressing [OK] continues the operation,
ignoring those parameters at maximum or minimum
value. Pressing [CANCEL] aborts the operation.
ELC-02/ELCU-M02 Owner's Manual
6
101