Table of Contents
Advertisement
To open the parameter list:
When you press a button, a parameter list will appear in
which you can select the desired parameter. When you
select items in the display, the list closes automatically.
You can also close the list by pressing the [CLOSE] button
at the top right of the list.
To change the parameter value:
To make coarse changes to the value, use the []/[]
buttons. For fine adjustment, use the Data Control dial.
Adjusting parameter values by
using the display sliders
You can adjust some parameters such as Volume, Reverb,
Pan and so on, by using the 'virtual' sliders in the display.
There are two ways to move the slider in the display:
touching it directly, and using the Data Control dial. We
suggest that you touch the display slider when making
coarse adjustments and use the Data Control dial for fine
adjustment.
Touching the display slider directly:
To change a display slider value, press the desired point in
the slider. The slider moves to the point that is pressed.
You can also change the parameter value by sliding your
finger up or down while holding down on the display
slider.
Using the Data Control dial:
Touch on/above the slider in the display to enable the
parameter and set a rough value, then turn the Data
Control dial.
Touch here to enable the parameter
DATA CONTROL
Blue mark
To control Pan, you can move the horizontal slider in the
same way as vertical sliders.
Using the LCD Display
Slider will move to the point you touch
Slider will follow your finger
DATA CONTROL
DATA CONTROL
ELC-02/ELCU-M02 Owner's Manual
1
15
Advertisement
Table of Contents
