Yamaha Electone STAGEA ELC-02 Owner's Manual page 200

Installing the Pedal unit
1-3
Hold the cable connector so that the two
lines on the connector are facing upward,
then carefully plug it into the inside
connector on the bottom of the Expression
Pedal.
1-4
Install the Expression Pedal to the
corresponding indentation on the Pedal unit
by first fitting the protrusion on the back
side and then fitting the front side as
shown.
As you fit it in position, the front side of the
Expression Pedal is slightly lifted. When installing
the Expression Pedal, be careful to avoid catching
the connector.
2
Tighten the screw.
Fix the Expression Pedal to the Pedal unit while
holding the Expression Pedal, using the screw you
removed in step 1-2.
3
As with the Expression Pedal, install the
2nd Expression Pedal, then fix it with
the screw.
200 ELC-02/ELCU-M02 Owner's Manual
4
Attach the hollow parts on the rear of
the Pedal unit to the corresponding
indentions on the frame of the stand, as
shown below.
Installation is completed.
To disassemble the unit, reverse the assembly
sequence.
NOTE
For information on installing the connecting cord, refer to
page 201.
Convenient carrying handle
You can transport the Pedal unit by holding the carrying
handle on the rear.
CAUTION
Do not hold the keys, since this may damage or result in
a malfunction.