JVC CA-MXS6MDR Service Manual page 24

CA-MXS6MDR
SP-MXS6MD
Removing the side unit (L) and (R)
Prior to performing the following procedures, remove
the servo control board, the top cover and the tray
unit.
1. Remove the two screws C attaching the side unit (L).
2. Slide and remove the side unit (L) toward the front
while releasing the two joints e and the joint f with
the chassis unit.
3. Slide the slide cam (L) toward the front until it stops
to place the sub chassis unit at the top position.
ATTENTION: The side unit (R) can be removed
when the sub chassis unit is located at
the top position.
4. Turn the hook gear counterclockwise to move the
slide hook and the slider (R) backward until they
stop.
5. Remove the three screws D attaching the side unit
(R). Raise the side unit (R) upward and release the
joint g with the chassis unit and the boss from the
select arm marked h. Then remove the side unit (R)
from the body.
ATTENTION: When reassembling, make sure the boss
is fitted to the select arm marked h.
D
Side unit (R)
Fig.9-4
1-24
(See Fig.9-1 to 9-5)
Boss
Select arm
Joint h
D
Joint h
Side unit (R)
Select arm
D
Hook gear
Joint g
slide hook
Slider (R)
D
Fig.9-1
Side unit (L)
Fig.9-2
Side unit (L)
Joint f
Fig.9-3
Side unit (R)
D
Fig.9-5
C
Joints e
Side unit (L)
C
Joint f
Slide cam(L)
Joints e
Joint g