JVC CA-MXS6MDR Service Manual page 32

CA-MXS6MDR
SP-MXS6MD
4.Disc adjustment
This adjustment should done after laser power adjustment.
Insert
Pre-master disc
Complete TOC read
Press [MD key] of
the Remote controller
LCD indication
ON TUNING
Start auto adjustment
Adjustment
OK?
LCD indication
OK_TUNING
Eject the
Pre-master disc
Insert the
Recordable disc
Complete TOC read
Press [MD key] of
the Remote controller
LCD indication
ON TUNING
Start auto adjustment
Adjustment
OK?
LCD indication
OK_TUNING
Press [STOP key] of
the Remote controller
Press [EJECT key]
of the main body
Complete the adjustment
1-32
[CAUTION]
Please push the [STOP key] to remote control when the
LCD display becomes [NG ERROR], and push the
[MD key] to remote control again.
/
LCD indication
NG_ERR _!
<Refer the NG code list>
<NG code list>
CODE Adjustment NG section
00 Auto adjustment not complete
01 REST switch detection
02 FOCUS ON
03 PIT section EF balance, tracking offset adjustment
04 PIT section ABCD level (IV impedance) adjustment
05 PIT section focus servo AGC
06 PIT section tracking servo AGC
07 PIT section focus bias adjustment
08 GRV section EF balance, tracking offset adjustment
09 GRV section ABCD level (IV impedance) adjustment
0A GRV section focus servo AGC
0B GRV section tracking servo AGC
0C GRV section focus bias adjustment
0D Room temperature
0E EEPROM writing
FF Auto adjustment complete (OK)
LCD indication
NG_ERR _!
<Refer the NG code list>