Table of Contents
Advertisement
Palette II Lighting Control Console
CONSOLE POWER UP
1. Power Up Procedure
Once the console has been installed and all components connected, the console and processor can be powered up.
To power up:
Step 1. At front of console, press power on/off button. When LED lights up, release button and console will boot.
Step 2. After boot up is complete, verify status by checking black status window at bottom of screen. If it says
"Outputs Disabled" you will need to enable them to On-Line status.
Step 3. To enable outputs, click "File" menu at top right of your screen and select "Enable Outputs." Black status
window should now say "On-Line."
Step 4. If you wish to view your hardware status, this can be found under the "Help" menu.
Step 5. Set your console's personality. This can be
found under "Hardware Setup" then clicking on
"Console". You will notice several options to
choose from:
a. GeniusPro (500 series) - GP: Command line
entry. Utilizes the British spelling of words,
for example "colour" vs. "color" and
"anticlockwise" vs. "counterclockwise".
This also uses the 500 series channel colors
(magenta is up, cyan is tracking).
b. LightPalette (500 series) - LP : Command
line entry. Utilizes US spelling and also uses
the 500 series colors (magenta is up, cyan is
tracking).
c. Palette Classic Europe - EU: Command Line
entry. Uses the British spelling as well as the
LP90 colors (cyan is up, magenta is
tracking).
d. Palette Classic US - US: Command Line
entry with US spelling and LP90 colors (cyan is up, magenta is tracking).
Note: All future definitions of button actions will assume the selection of Palette Classic US. This will send all
action buttons directly to the command line. If the dialogue box is requested, just press [SHIFT] then the action
button.
Installation & Setup Guide
13
Console Power Up
Advertisement
Table of Contents
