Table of Contents
Advertisement
Installation & Setup Guide
4. Copy
• Highlight the cues you want to copy with the blue box, then press [SHIFT] [COPY] [NUMBER] [ENTER] to copy
the selected cue(s) to new cue(s).
• Press [COPY] [LOOK] to copy a Look.
• Press [COPY] [CUE] to copy a Cue.
• Use [#] [COPY] [#] [ENTER] to copy attributes from one channel to another.
• Use [SHIFT] [COPY] [BUMP] [BUMP] to copy one Look to another.
5. Cue
• A Cue is an item that has stored levels that can be played back in a set time. To record a cue, set a selection of
channels at levels then type [RECORD] [ENTER] to record the next available whole cue number. If none are
present, this will record cue 1. You can also record any cue number by typing [RECORD] [CUE] [1] [ENTER]. or
Change times by [CUE] [1] [TIME] [5] [ENTER] or jump to a cue with [GOTO] [CUE] [1] [ENTER]. More
advanced commands will be discussed later.
6. Dead Black Out Buttons (DBO)
• Use these buttons to black out the stage.
• This button can be configured to work as a momentary button, a toggle button, or be disabled. See
Out (DBO)" on page 56
7. Delete
• The Delete feature allows removal of recorded items from a show. For example, [DELETE] [CUE] [1] [ENTER]
and [DELETE] [LOOK] [1] [ENTER].
• [SHIFT] [DELETE] will activate the Delete dialogue box.
8. Edit
• Pressing the [EDIT] button allows changes to the highlighted cells in the Cue List or Look display (times, labels,
follows etc.) or in the patch displays. Move the blue highlighted cells using the [ARROW KEYS].
• If a range is selected, typing in a new value will change all cells to that value.
• If editing a numeric column (such as Time), after pressing [EDIT] use
the level wheel to change the values. If multiple cells are selected, the
values will change relative to each other. In the example on the right, if
the wheel is used to change the '3' to a '4', the '2' would change to a '3'
and the '1' would change to a '2'.
• Holding down [SHIFT] while rolling the level wheel while editing cells will change numeric values by 0.1.
9. Go
• Go will run a cue in the recorded time. Note: [SELECT] button does not have to be active (amber LED flashing).
• If a cue is running, the Green LED will be flashing.
• If you are sitting in a cue, the LED will be solid Green.
• If the Cue List is releasing, both the [GO] and the [HALT/BACK] LEDs will be flashing.
• [SHIFT] [GO] asserts the Cue List, grabbing full control of its attributes without advancing the Cue List.
2 4
Controls
for setup details.
Palette II Lighting Control Console
"Dead Black
Advertisement
Table of Contents
