Using The Safety-Interlock System; Positioning The Seat - Toro Z Master Professional 6000 Series Operator's Manual

Using the Safety-Interlock
System
WARNING
If safety-interlock switches are disconnected
or damaged, the machine could operate
unexpectedly causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily, and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
engine from starting unless:
•
The parking brake is engaged.
•
The blade-control switch (PTO) is disengaged.
•
The motion-control levers are in the N
position.
The safety-interlock system also is designed to shut off
the engine when the traction controls are moved from
the locked position with the parking brake engaged or
if you rise from the seat when the PTO is engaged.
The hour meter has symbols to notify the user when
the interlock component is in the correct position.
When the component is in the correct position, a
triangle lights up in the corresponding square.
1. Triangles light up when the interlock components are in the
correct position
Testing the Safety-Interlock
System
Service Interval: Before each use or daily
Test the safety-interlock system before you use the
machine each time. If the safety system does not
EUTRAL
Figure 11
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1. Sitting on the seat, engage the parking brake
and move the blade-control switch (PTO) to the
O position. Try starting the engine; the engine
N
should not start.
2. Sitting on the seat, engage the parking brake
and move the blade-control switch (PTO) to the
O position. Move either motion-control lever
FF
(out of the N
the engine; the engine should not start. Repeat
for the other control lever.
3. Sitting on the seat, engage the parking brake,
move the blade-control switch (PTO) to the O
position, and move the motion-control levers
to the N
engine. While the engine is running, disengage
the parking brake, engage the blade-control
switch (PTO), and rise slightly from the seat; the
engine should shut off.
4. Sitting on the seat, engage the parking brake,
move the blade-control switch (PTO) to the O
-
LOCK
position, and move the motion-control levers
to the N
engine. While the engine is running, center
either motion control and move (forward or
reverse); the engine should shut off. Repeat for
other motion control.
5. Sitting on the seat, disengage the parking brake,
move the blade-control switch (PTO) to the O
position, and move the motion-control levers
to the N
engine; the engine should not start.

Positioning the Seat

The seat moves forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
To adjust, move the lever sideways to unlock the seat
(Figure 12).
g009181
19
- position). Try starting
EUTRAL LOCK
- position. Now start the
EUTRAL LOCK
- position. Now start the
EUTRAL LOCK
- position. Try starting the
EUTRAL LOCK
Figure 12
FF
FF
FF
g019754