Product Overview; Controls - Toro Z Master Professional 6000 Series Operator's Manual

Product Overview

1. Height-of-cut deck-lift
pedal
2. Transport lock
3. Parking-brake lever

4. Controls

5. Motion-control levers
6. Roll bar
Controls
Become familiar with all the controls before you start
the engine and operate the machine
Figure 5).
1. PTO switch
2. Choke control
3. Throttle control
Figure 4
7. Seat belt
8. Fuel cap
9. Mower deck
10. Caster wheel
11. Z Stand
(Figure 4
Figure 5
4. Hour
meter/safety-interlock
display
5. Ignition switch
6. Fuses
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance
Fuel Gauge
The fuel gauge is located with the hour meter, and
the bars light up when the ignition switch is in the O
position (Figure
The indicator light appears when the fuel level is low
(approximately 1 gallon remaining in the fuel tank).
Safety-Interlock Indicators
There are symbols on the hour meter that indicate
g027964
with a black triangle that the interlock component is
positioned correctly
Battery-Indicator Light
If you turn the ignition key to the O
few seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when the ignition is turned
on and when the charge is below the correct operating
level (Figure
and
1. Fuel gauge (bars)
2. Battery light
g008951
3. Hour meter
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure
13
(Figure 5).
5).
(Figure 6).
N
6).
Figure 6
4. Safety-interlock symbols
5. Low fuel-indicator light
5).
N
position for a
g008950
to F
LOW AST