Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro Z Master Professional 6000 Series Operator's Manual

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
U position for the transport position
NLOCK
Figure 28
Transport-Lock Positions
1. Transport lock
2. L position—mower
OCK
deck locks into transport
position
position and an
OCK
(Figure 28).
g032377
3. U position—does
NLOCK
not lock the mower deck
into transport position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
29).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
1. Deck-lift pedal
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
27
Figure 29.
(Figure
29).
Figure 29
3. Transport lock
EUTRAL
g027343
-
LOCK