Using The Motion-Control Levers; Driving The Machine - Toro Z Master Professional 6000 Series Operator's Manual

Shutting Off the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
Let the engine idle at slow throttle (turtle) for 60
seconds before turning the ignition switch to the O
position.
Figure 24
Important:
Make sure that the fuel-shutoff valve
is closed before transporting or storing the
machine, as fuel leakage may occur. Engage the
parking brake before transporting. Make sure that
you remove the key as the fuel pump may run and
cause the battery to lose charge.
Using the Motion-Control
Levers
FF
1. Motion-control
lever—N
EUTRAL
position
2. Center, unlocked position
3. Forward

Driving the Machine

The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
g027337
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance. Always operate in the full throttle
position when mowing.
24
Figure 25
4. Backward
-
LOCK
5. Front of machine
position for best
AST
g004532