ABB TPS48-F Series Operation Manual page 44

Operation Manual / TPS44-F.. - TPS61-F..
4 Operation / 4.4 Speed measurement
4.4.1 Speed differences with multiple turbochargers per
© Copyright 2020 . All rights reserved.
engine
The speeds of all turbochargers on one engine differ only slightly from
each other in normal operation.
The difference between the highest and the lowest turbocharger speed
must not be more than 3 % relative to the speed limit n
If this permissible range of difference is exceeded, the following steps
must be carried out:
Reduce engine performance immediately until the highest turbochar-
u
ger speed no longer exceeds 70% of n
If the engine cannot be stopped, continue to run at this reduced en-
u
gine performance or turbocharger speed.
If the turbocharger surges continuously, engine performance must be
u
reduced further.
Measure the temperatures in the air and gas lines to and from the tur-
u
bochargers and compare them with standard values.
If the engine can be stopped for a short time:
Inspect the air and gas lines as well as the turbocharger and eliminate
u
any problems.
In any event, it is recommended that you contact the nearest ABB Tur-
u
bocharging Service Station.
HZTL2412_EN
.
Bmax
.
Bmax
Rev.G March 2020